Thursday, June 13, 2013

Project Ideas for Embedded System Design

Dear Students,

This post is for students who want to do a mini-project in Embedded Systems Domain

Here are some tips on how to effectively begin and complete your mini-project.

STEP 1:
Select a sensor group and an actuator group. Give the title for the mini-project  as 'A comparative study of applications with xxx-sensors using yyyy-microcontroller and zzzz-actuator'. Later of course you can change the title to a more appropriate and specific one.
STEP 2:
Identify the companies and sensor/actuator variants and collect all the specifications required to understand and interface the devices to your microcontroller.
STEP 3:
Begin designing very simple interfaces using your sensor and actuator to your microcontroller. After a few trials you will begin to understand and get a grip on the functioning of these devices. Until then, work hard and be patient. Then, you will be able to finalise the circuit required to interface the sensor/actuator to the microcontroller.
STEP 4:
Begin taking a closer look at the sensor. Understand its behaviour in greater detail and how the physical parameter can be converted to binary data that is readable by the microcontroller. Here, you will have to shift from using an interface that gives only a HIGH or LOW signal to an interface that gives a 4-, 8-, 16- or 32-bit output. Of course you must then know how to use an ADC of the required resolution. Hopefully, another group must be ready with this expertise to help you !
STEP 5:
Once you are clear about the smaller details of interfacing, your next task will be to make the microcontroller DO SOMETHING INTELLIGENT (Programming !) to the actuator based on the input data given by the sensor. Here is where your programming skills will help. Also, having the source code for some standard operations will help immensely as C-Progamming is all about reusability of the code ! Do not re-invent the wheel.
STEP 6:
You either create a useful application with this OR can go further by taking another sensor of the same group, repeat the above steps and then compare your results. That becomes a comparative study.

Please note : Such studies involving hardware, software, sensors and actuators will be highly appreciated by academicians as it will help you to project your command and understanding of the work you have done. 

Hope this is of some help !

Good Day
HoD-ECE-SVIT


1 comment:

  1. we are doing the same as you mentioned sir ,we selected LPC1768 micro controller which is based on ARM architecture.Initially we started with small interfaces like LED's & SWITCHES and after that we tried to interface LCD,7-SEG & motors.Next we are trying to interface optical encoders,servos,touch screens etc.We are using keil micro vision tool to do the programming,basically in C language.
    I PERSONALLY FOUND OUT THE FOLLOWING ADVANTAGES TO DO ANY PROJECT IN HOUSE:

    1.we dont get any program correct at first but on debugging the code we learn where the problem is eventually,THIS INCREASES OUR PROBLEM SOLVING SKILLS.

    2.some times you right a code for a particular application but the first think i do after i succesfully execute it is to reduce the size of the code.

    3.personally i recommend to use C-programming than assembly language programming because to program in ALP you need to have a complete idea about the internal architecture of the device this is not entirely the case with C-language,because it is highly user friendly.

    4.finally the most important thing NEVER think you have no idea about microcontrollers or microprocessors.Never jump into complex programming."ALWAYS START FROM SCRAP"

    CHOOSE YOUR DEVICE START FROM SCRAP ENJOY YOUR PROJECT

    ReplyDelete