Dear Students,
This post is for students who want to do a mini-project in Embedded
Systems Domain
Here are some tips on how to effectively begin and
complete your mini-project.
STEP 1:
Select a sensor group and an actuator group. Give
the title for the mini-project as 'A comparative study of applications
with xxx-sensors using yyyy-microcontroller and zzzz-actuator'. Later of course
you can change the title to a more appropriate and specific one.
STEP 2:
Identify the companies and sensor/actuator variants
and collect all the specifications required to understand and interface the
devices to your microcontroller.
STEP 3:
Begin designing very simple interfaces using your
sensor and actuator to your microcontroller. After a few trials you will begin
to understand and get a grip on the functioning of these devices. Until then,
work hard and be patient. Then, you will be able to finalise the circuit
required to interface the sensor/actuator to the microcontroller.
STEP 4:
Begin taking a closer look at the sensor.
Understand its behaviour in greater detail and how the physical parameter can
be converted to binary data that is readable by the microcontroller. Here, you
will have to shift from using an interface that gives only a HIGH or LOW signal
to an interface that gives a 4-, 8-, 16- or 32-bit output. Of course you must
then know how to use an ADC of the required resolution. Hopefully, another
group must be ready with this expertise to help you !
STEP 5:
Once you are clear about the smaller details of
interfacing, your next task will be to make the microcontroller DO SOMETHING
INTELLIGENT (Programming !) to the actuator based on the input data given by
the sensor. Here is where your programming skills will help. Also, having the
source code for some standard operations will help immensely as C-Progamming is
all about reusability of the code ! Do not re-invent the wheel.
STEP 6:
You either create a useful application with this OR
can go further by taking another sensor of the same group, repeat the above
steps and then compare your results. That becomes a comparative study.
Please note : Such studies involving hardware,
software, sensors and actuators will be highly appreciated by academicians as
it will help you to project your command and understanding of the work you have
done.
Hope this is of some help !
Good Day
HoD-ECE-SVIT
we are doing the same as you mentioned sir ,we selected LPC1768 micro controller which is based on ARM architecture.Initially we started with small interfaces like LED's & SWITCHES and after that we tried to interface LCD,7-SEG & motors.Next we are trying to interface optical encoders,servos,touch screens etc.We are using keil micro vision tool to do the programming,basically in C language.
ReplyDeleteI PERSONALLY FOUND OUT THE FOLLOWING ADVANTAGES TO DO ANY PROJECT IN HOUSE:
1.we dont get any program correct at first but on debugging the code we learn where the problem is eventually,THIS INCREASES OUR PROBLEM SOLVING SKILLS.
2.some times you right a code for a particular application but the first think i do after i succesfully execute it is to reduce the size of the code.
3.personally i recommend to use C-programming than assembly language programming because to program in ALP you need to have a complete idea about the internal architecture of the device this is not entirely the case with C-language,because it is highly user friendly.
4.finally the most important thing NEVER think you have no idea about microcontrollers or microprocessors.Never jump into complex programming."ALWAYS START FROM SCRAP"
CHOOSE YOUR DEVICE START FROM SCRAP ENJOY YOUR PROJECT